Omron PLC Center

“Change” PLC old version of the “new” to reduce costs. Decrease in production. How to optimize each.

Change the PLC to your old, better … to help save money on the maintenance of the lower Decrease in production. Because the stability in the new work. Reduce waste at work. Add high performance version is a lot to choose from. A new function. Easy to use, easy to choose …

Old generation
C20, C @ @ P, C @ @ K, C @ @ H, CPM1/CPM1A, CPM2A.

The new version is CP1E.

Feature:
-Supported I / O up 160 points.
-Sequence for a simple program.
-Supports High-speed pulse Input / Output. (more…)

Tags: C1000H, C120, C2000H, C200H, C500, CJ1 / CJ2, CP1E, CP1H, CP1L, CPM1/CPM1A, CPM2A, CQM1, CQM1H, CVM1, omron plc, Omron Product, plc, PLC ProductC1000H, C120, C2000H, C200H, C500, CJ1 / CJ2, CP1E, CP1H, CP1L, CPM1/CPM1A, CPM2A, CQM1, CQM1H, CVM1, omron plc, Omron Product, plc, PLC Product

Share This

I work around a CP1H R88D servo with a pulse output 0 problem. All power settings are standard, except for the electronic gear ratio. The example is the Handbook of 2000 pulses per revolution motor set.
Fine adjustment of the drive car (one horizontal spindle).

I have the move to Omron (power) function block in the CP1H.
The distance between the CP1H and the servo is about 6 m (2 m). The drive is a Panasonic with brake and encoder (not absolute).

Two cases:
1. 2000 pulses is not a revolution engine, only about 3 / 4 2000 pulses also not equal to 2000 forward pulse times (by a significant amount).
2. The highest speed I can use and still move the actuator 100, although I keep hearing that the CP1H is capable of more. The CP1H seems not the problem. When ordered with a speed of more than 100, the power simply ignore the incoming pulse.

I’ve been through all CP1H/R88D manual and found no answers. Has anyone successfully ran a similar sytem? Anyone have a hint of things to look for? (more…)

Tags: CP1H, CP1H R88D, Motor, Motor controller, plc, PLC Product, PLC software, R88, Servo moterCP1H, CP1H R88D, Motor, Motor controller, plc, PLC Product, PLC software, R88, Servo moter

Share This

Today,PLC exemple programming will be present control servo with PLC CP1H connect to Omron Servo Driver (Smart Step)
1. Run Omron CX-programmer and then select [File] -> [New] menu appears dialog block as shown below.

2. Select [CP1H] from the Device Type.

Click [Settings] dialog block “Device Type Settings” will show the following. (more…)

Tags: Control servo motor, CP1H, CX Programmer, Motor, Omron CP1H, PLC CP1H, PLC ladder Exemple, PLC programming, Servo Driver, servo motor, Smart StepControl servo motor, CP1H, CX Programmer, Motor, Omron CP1H, PLC CP1H, PLC ladder Exemple, PLC programming, Servo Driver, servo motor, Smart Step

Share This